Reballing Kits .

View previous topic View next topic Go down

Reballing Kits .

Post by Hertz on Fri Jun 17, 2011 8:43 pm


Re-balling kits are used to repair broken or weak soldered BGA (Ball Grid Array) Chips.

This is very important tools when it comes to hardware problem troubleshooting in various mobile phones.
This is only being used when an IC or chips was being suspected having fault or causes the problem.
That is because Mobile phones used BGA (ball grid array) solder balls that holds as connection terminal of every chips.

[You must be registered and logged in to see this image.]

There are many kits you can buy via online this days unlike before that most of mobile phone technician was unable to used this kits for it was not too easy to find and purchase. The process is that they just remove the entire solder balls and flattened out the entire bump terminal then replace the chips again. It may work but not totally effective as like for my years experience for the soldering process is too weak and easy to break , because the amount of soldered balls that holds the chips is not strong enough to hold it.
Althought reballing IC's is not that easy for beginners to tackle to. it needs training and proper procedures to follow, further we will discuss the easiest way on how to reball IC chips.

[You must be registered and logged in to see this image.]

These are the kits you must prepare to be able to proceed in reballing BGA chips.

A Solder Balls
Solder balls have different sizes and measured by diameter,that match on every chips bumps sizes also.
These are the common Soldering Ball diameter ranges for mobile phones chips.
0.05, 0.10, 0.15, 0.20, 0.25mm, 0.30mm, 0.35mm, 0.40mm,0.45mm,0.50mm ,0.55mm ,0.60mm, 0.65mm, 0.76mm

[You must be registered and logged in to see this image.]

A BGA Stencil Pattern Plates
This is being used to properly align the solder ball on every bumps of the chips.

[You must be registered and logged in to see this image.]

every chips have different bumps pattern and alignment designs.

[You must be registered and logged in to see this image.]

Spatula
this is used to gathered the solder ball on each holes of the Stencil plates.
[You must be registered and logged in to see this image.]

A liquid Flux
[You must be registered and logged in to see this image.]

A PCB Board Holder
a PCB holder is being used to maintain the accuracy while working soldering and to avoid gripping and misalignment of solder balls.

[You must be registered and logged in to see this image.]

A Cleaning liquid
Too many cleaning product offered today that is non flammable.
A lacquer thinner will work, and still widely used for many mobile phone technician.

[You must be registered and logged in to see this image.]

A cotton buds

[You must be registered and logged in to see this image.]

A Brush

[You must be registered and logged in to see this image.]


Source: cellphonerepairtutorials.blogspot.com

_________________
3rd member of STTM
former 4th member

Hertz
Admin
Admin

Posts : 1475
Join date : 2010-08-12
Age : 36
Location : Cagayan De Oro City

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum